Siding Repair in Olympic Valley
Olympic Valley's housing boomed in the 1970s around the base of what is now Palisades Tahoe, and Census figures for the 96146 ZIP put the median home in the early 1980s, with about seven in ten used seasonally. That's a large stock of 40- and 50-year-old ski homes, many clad in wood or hardboard set close to grade and decks, now meeting the limits of their original siding.
Siding on these homes fails from the bottom up and around decks and eaves, where snow sits longest. We repair those sections, raise the clearances that caused them, and plan the work for owners who often aren't there when it starts. The general method is on our [siding repair](/siding-repair) page.
Free estimate
Get your free Olympic Valley estimate
On-site assessment with a written, itemized scope. We reply within one business day.
Licensed, Bonded & Insured
Hardboard siding on 1970s and 1980s ski chalets
Hardboard is a wood-fiber product, and once water gets past its paint, typically at bottom edges, butt joints, and nail holes, it swells, softens, and doesn't recover. A swollen bottom edge or a board that has gone spongy around its nails is past saving. Repair means replacing the affected boards, and the challenge is matching: many hardboard profiles from this era are no longer made. We try for the closest available profile, and where nothing works, we often move that full elevation to fiber cement so the change lands at a corner. In Olympic Valley that means the HZ5 product line, which James Hardie's ZIP lookup returns for 96146. Our repair or replace guide covers when hardboard has reached the end.
Bottom courses that have sat in snow since the house was built
Palisades Tahoe reports about 400 inches of snow a year on the mountain, and NOAA normals from Tahoe City show around 200 nights a year at or below freezing. On older Olympic Valley homes, siding often runs down close to grade or a deck surface, so snow banks against it all winter and freeze-thaw opens every joint. When we repair this band, we cut the siding back to a proper clearance above grade and decks, probe the sill and lower sheathing, replace what's decayed, and flash the deck ledger before the new courses go on. Repairing at the old height only resets the clock.
Damage that waits for a seasonal owner
With most homes here used seasonally, a cracked board or failed flashing can take on water for months before anyone notices. When we're called, we photograph the damaged area before and after opening it, show you what's behind the siding, and agree decisions in advance where possible so work can move ahead without you on site. Repairs fit between snowmelt and the first real storms, and we keep the house closed up at the end of each day. If you find a problem late in the season, a temporary weather seal can protect the wall until there's a window for the full repair.
Design review and HOA rules before replacement material goes up
Olympic Valley is unincorporated, so permits go through Placer County. It sits outside the Tahoe Regional Planning Agency's basin boundary, so TRPA's rules generally don't apply here the way they do on the lake. Placer County has an Olympic Valley Design Review Committee and a community plan for the valley, and condominium and townhome buildings usually have association rules on exterior changes. A like-for-like repair may need little, while switching material or color on a whole elevation may need sign-off. Confirm both before choosing what goes back on the wall. Our Hardie color matching guide helps when a repair has to blend with existing fiber cement.
Why this matters in Olympic Valley
- Specified for North Tahoe / Sierra Alpine conditions
- James Hardie as the recommended system
- Correctly detailed weather-resistive barrier and flashing
- Installed by a crew with 20 years combined experience
Recommended systems for Olympic Valley
- James Hardie
- fiber cement
Siding Repair for Olympic Valley homes
The full siding repair approach — materials, weather-resistive detailing, and the manufacturer standards we install to — is covered on the main service page, then specified for Olympic Valley's conditions on this one.
Our Olympic Valley process
- Step 1
Consultation
We listen to your goals and assess your home on site — exposure, substrate, and architecture.
- Step 2
Design & Proposal
A clear written proposal with the right system specified for your climate and a transparent scope.
- Step 3
Expert Installation
Trained crews install to manufacturer best practices with careful weather-management detailing.
- Step 4
Walkthrough & Support
A final walkthrough, full cleanup, and a clear written record of the scope completed — work we stand behind.
FAQ
Siding Repair in Olympic Valley — FAQ
Often, if the damage is limited to a few boards and the sheathing is sound. The harder part is finding a matching profile. If nothing close exists, moving that elevation to fiber cement is usually the cleaner repair.
It depends on the scope. Swapping a few boards to match is different from changing material or color across an elevation. Check with Placer County about the Olympic Valley Design Review Committee and with your HOA if you have one.
We stop and show you, with photos if you're away. Then we cut back to sound wood, replace sheathing or framing as needed, flash the ledger, and agree the added scope with you before closing the wall.
HZ5. James Hardie's ZIP lookup returns HZ5 for 96146, the line designed for freeze-thaw and snow.
Keep Exploring
More for Olympic Valley homeowners
More in Olympic Valley
Other exterior services in Olympic Valley
Nearby Service Areas
Siding Repair near Olympic Valley
Back to
Placer County & Olympic Valley
Helpful Exterior Guides

