Lamorinda and the San Ramon Valley
Our Contra Costa work centers on the hill towns east of the Caldecott Tunnel — Orinda, Lafayette, and Moraga — and the San Ramon Valley communities of Danville and Alamo. Census figures show the county's median home was built in the late 1970s, and in Orinda and Lafayette roughly two-thirds of homes predate 1970. That is a large stock of ranch and mid-century hillside homes whose original wood or hardboard siding, trim, and windows are at or past the end of their life.
Inland heat, not Bay fog
All five towns are in California Energy Commission Climate Zone 12 — the same inland zone as Sacramento, not the foggy coastal zones of Oakland or San Francisco. Summers are hot and dry, the oak-and-grass hills cure to fuel by midsummer, and south- and west-facing walls take hard sun. For exteriors that means UV-stable factory finishes, real expansion detailing, and — above all — fire performance.
Permit, fire, and utility authorities
Orinda, Lafayette, and Moraga contract building permits to Contra Costa County's Department of Conservation and Development after city or town planning review; Danville runs its own building division; unincorporated Alamo goes straight to the county. Fire protection splits among the Moraga-Orinda Fire District (Orinda and Moraga), Contra Costa County Fire Protection District (Lafayette), and San Ramon Valley Fire Protection District (Danville and Alamo). Water for all five comes from EBMUD; electricity is PG&E, with MCE community choice service in Danville, Lafayette, Moraga, and unincorporated areas.
HZ10 and the 2025 fire hazard maps
Contra Costa's Bay Area towns are in James Hardie's HZ10 climate zone; installing HZ5 product here is a documented warranty misapplication. On fire, the state's 2025 Local Responsibility Area maps expanded hazard zones across Lamorinda: Orinda's Very High acreage roughly doubled from the 2011 map, and Lafayette's city figures show most of the city mapped High. Where a home is in a High or Very High zone, California's WUI building code governs new exterior work — siding, vents, decks, and windows included. Check your parcel on the OSFM Fire Hazard Severity Zone viewer.
Climate and exterior risk in Contra Costa County
The Lamorinda and San Ramon Valley towns sit inland of the Berkeley Hills, which block most of the Bay's marine layer. Summers run hot — Wikipedia's Lafayette article notes inland highs can top 100°F while bayside areas run up to 20°F cooler — and winters are mild and wet. The exterior stresses are UV and heat cycling on sun-facing walls, winter rain on north and shaded elevations, and the fire season in between.
Wildfire exposure in Contra Costa County
Fire is the defining exterior issue in Lamorinda. The 1991 Oakland Hills firestorm started just west of the Caldecott Tunnel, and the hills that run through Orinda, Moraga, and Lafayette carry the same oak, grass, and brush fuels. Our sampling of the state's 2025 maps suggests most of Orinda is Very High, Moraga is split between Very High and High, Lafayette is mostly High, and Alamo includes State Responsibility Area land rated High along its western hills. Danville is mostly Moderate or outside the mapped zones, with High areas on its hillsides.
Moisture in the inland East Bay
There is no snow and little fog here, but winter storms still drive rain into poorly flashed windows and failing joints, and shaded north walls under oaks stay damp. Most moisture damage on older Lamorinda homes is at window sills, the bottom courses, and deck ledgers — fixed during a re-side with proper flashing and clearances.
Recommended materials for Contra Costa County
Factory-finished James Hardie fiber cement in the HZ10 line is the default recommendation: it is non-combustible for the High and Very High fire zones, holds a factory finish far longer than field-painted wood in inland sun, and does not rot. Pair it with ember-resistant vents, hardened eaves, a non-combustible zone at the base of the wall, and properly flashed windows. See our fire-resistant exteriors guide.
FAQ
Contra Costa County — Common Questions
Yes — Orinda, Lafayette, Moraga, Danville, Alamo, and the surrounding Lamorinda and San Ramon Valley communities, for siding, exterior renovation, and window projects.
Orinda, Lafayette, and Moraga review projects at the city or town planning level and contract building permits to Contra Costa County's Department of Conservation and Development. Danville has its own building division; unincorporated Alamo uses the county.
If your parcel is in a High or Very High Fire Hazard Severity Zone, California's WUI code governs new exterior work, including siding. Much of Orinda is mapped Very High and most of Lafayette High under the 2025 maps — check your parcel.
California Energy Commission Climate Zone 12 — hot, dry inland summers, not the foggy coastal zones closer to the Bay. Siding here has to handle sun and heat as well as fire.
HZ10, like the rest of the Bay Area. HZ5 is engineered for freeze-thaw climates and is a warranty misapplication here.

