Skip to content
Sierra Siding

Dry Rot Repair · Martis Camp, Placer County

Dry Rot Repair in Martis Camp, CA

Rotted siding, trim and sheathing opened up, replaced and flashed so it stays dry for Martis Camp homes — specified for Sacramento Region & Sierra conditions and built to last.

Dry Rot Repair for large mountain contemporary homes in Martis Camp, California

Dry Rot Repair in Martis Camp

On Martis Camp's large custom homes, the wood most likely to decay is often not the siding at all. It's the heavy timber, the exterior stairs on sloped lots, the deck framing, and the eaves under complex rooflines, all of which sit at about 6,200 feet with Truckee-area snow and plenty of freeze-thaw. As the community's first generation of homes ages, those structural pieces are where we find the problems that matter most.

Martis Camp carries Truckee addresses but sits in unincorporated Placer County, so any permit for structural repair comes from Placer County. Many homes are used seasonally, and the community commonly reviews visible changes, so we plan the work around both. Our general method is on the [dry rot repair](/dry-rot-repair) page.

Free estimate

Get your free Martis Camp estimate

On-site assessment with a written, itemized scope. We reply within one business day.

Licensed, Bonded & Insured

Stair stringers on slopes above the Martis Valley

Homes on sloped lots often reach their entries and decks by long exterior stairs, and the stringers are where we find serious decay. Each notch cut for a tread exposes end grain, snow sits on the treads, and the stringer feet rest on pads or soil that stay wet after melt. A stair can look fine from above while the bottom foot of each stringer has softened. We probe every stringer at the base and at each notch, check the connection at the top landing, and replace decayed stringers rather than patching them, since a stair is not a place to gamble. New stringers sit on a raised base with a gap from the pad so they can dry.

Timber posts and beam ends on designed exteriors

Heavy timber is part of the look here, and it fails at its ends. Posts set directly on stone or concrete pull water up into their base, and beam ends that run past the roofline take meltwater straight into the end grain. Deep checks in big timbers hold water too. We use an awl and small test holes, plugged afterward, to find how far decay runs. A decayed post base can sometimes be cut off and set on a raised standoff base, and a beam tail can often be cut back and capped. If decay reaches a bearing point, we bring in an engineer's review before cutting, and the repair is planned to match the timber's size and finish so it still suits the house.

Ice at the eaves and the fascia behind it

Large rooflines with several valleys and long eaves collect ice at the edge in a hard winter. Meltwater backs up behind that ice, runs over or behind the gutter, and soaks the fascia, the rafter ends, and the top of the wall. By summer the paint may only look tired. We probe fascia ends and rafter tails along each eave, trace the water back to the valley or roof-to-wall junction that feeds it, and repair the wood along with the flashing that let water past. Where ice is a repeat problem on one eave, we explain the options to you and the roofer rather than rebuilding the same fascia every few years.

Guest houses and cabins that get inspected last

Some lots carry a guest house or cabin as well as the main home. These buildings see less use, their gutters get cleaned less often, and nobody walks around them after a storm, so decay can run unchecked longer than on the main house. When we inspect a property, we include the secondary buildings in the same walk, probing their lower walls, decks, and entry stairs. Repairs to them follow the same approach and the same community review, and putting them on one estimate saves a second mobilization in a short season.

Why this matters in Martis Camp

  • Specified for Martis Valley / Sierra Alpine conditions
  • James Hardie as the recommended system
  • Correctly detailed weather-resistive barrier and flashing
  • Installed by a crew with 20 years combined experience

Recommended systems for Martis Camp

  • James Hardie
  • fiber cement

Dry Rot Repair for Martis Camp homes

The full dry rot repair approach — materials, weather-resistive detailing, and the manufacturer standards we install to — is covered on the main service page, then specified for Martis Camp's conditions on this one.

Full Dry Rot Repair details →

Our Martis Camp process

  1. Step 1

    Consultation

    We listen to your goals and assess your home on site — exposure, substrate, and architecture.

  2. Step 2

    Design & Proposal

    A clear written proposal with the right system specified for your climate and a transparent scope.

  3. Step 3

    Expert Installation

    Trained crews install to manufacturer best practices with careful weather-management detailing.

  4. Step 4

    Walkthrough & Support

    A final walkthrough, full cleanup, and a clear written record of the scope completed — work we stand behind.

FAQ

Dry Rot Repair in Martis Camp — FAQ

Stringers usually decay at the bottom and at the tread notches, where you can't see from above. A probe at those points tells us whether the stair is sound.

Sometimes. If the decay is confined to the base, the post can often be cut back and set on a raised base. If it runs up into the post or a beam bearing, we get an engineer's review before deciding.

Like-for-like repairs are usually simpler, but changes to visible material, profile, or color are commonly reviewed. Confirm with the community before work is scheduled. Any fiber cement we use is HZ5, which James Hardie's lookup returns for 96161.

Our nearby Truckee dry rot repair cost guide covers the snow-country factors. For early warning signs, see signs of dry rot behind siding.

Free Estimate

Dry Rot Repair in Martis Camp — Free Estimate

Serving Martis Camp and the surrounding Placer County. No pressure, no obligation.

Free, No-Obligation Estimates 20 Yrs Combined Experience Fire-Resistant Systems
(530) 772-5057Free Estimate