Skip to content
Sierra Siding

Fire-Resistant Siding · Martis Camp, Placer County

Fire-Resistant Siding in Martis Camp, CA

Class A non-combustible, hardened exterior systems for Martis Camp homes — specified for Sacramento Region & Sierra conditions and built to last.

Fire-Resistant Siding for large mountain contemporary homes in Martis Camp, California

Fire-Resistant Siding in Martis Camp

Martis Camp is roughly 2,200 acres of large custom homes on forested lots between Truckee and Northstar, and spot checks of CAL FIRE's State Responsibility Area maps put most of it in a Very High Fire Hazard Severity Zone. Not all of it: at least one point checked fell outside the mapped zones, which is why fire hardening here starts with looking up your specific parcel rather than assuming.

The houses themselves raise the stakes. Architect-designed exteriors in timber, stone, and wood siding, surrounded by trees, put combustible material close to a lot of fuel. The work is to keep what makes the design valuable while replacing the parts of the wall that would carry an ember into the house.

Free estimate

Get your free Martis Camp estimate

On-site assessment with a written, itemized scope. We reply within one business day.

Licensed, Bonded & Insured

Truckee Fire's three zones applied to the wall

Fire protection in Martis Camp comes from the Truckee Fire Protection District, which publishes defensible-space zones of 0–5 feet, 5–30 feet, and 30 to at least 100 feet. Landscaping handles the outer two; the innermost zone is where the building itself takes over. In the first five feet, the wall needs non-combustible cladding and trim, no mulch or stored firewood against the foundation, and nothing that lets needles pile up where the siding meets grade. On a forested lot, that band and the decks attached to it decide more about ember exposure than any single product choice.

Replacing aging wood without losing the architecture

Stained wood at altitude bleaches and checks quickly under summer sun, and it burns. Factory-finished James Hardie fiber cement is non-combustible under ASTM E136, Class A rated, and available in board-and-batten, lap, panel, and shingle profiles that sit well beside stone bases and heavy timber. In Martis Camp the correct product is the HZ5 line — Hardie's ZIP lookup returns HZ5 for 96161 — and HZ10 is a warranty misapplication. Where an owner wants to keep some real wood, we move it up the wall and away from decks so it is not in the zone embers reach first. Our wood vs. fiber cement fire comparison covers the trade-off.

Eaves, vents, and generous mountain rooflines

Large rooflines and deep overhangs are a signature of these homes, and the underside of a roof is a classic ember trap. We look at every eave and soffit, every attic and crawlspace vent, and every gap where trim meets the roof. Typical scope is ember-resistant vents, enclosed or hardened soffits in non-combustible material, and metal flashing at roof-to-wall intersections. Those same intersections handle ice and roof slide in winter, so we detail them for both — a joint that stops embers but lets meltwater behind the cladding is not finished. See our guide to soffit and attic ventilation.

Decks, stairs, and windows facing the forest

Deck ledgers and stair stringers are already the usual failure points on these homes because snow and ice sit there, and decks are also where needles collect against the wall. We flash ledgers, keep cladding off the deck surface, and detail the joint so debris has nowhere to lodge. Glass facing trees is exposed to radiant heat; when a re-side opens the wall around older windows, it is the right time to discuss tempered or dual-pane units integrated into the new weather barrier. Our fire-resistant exteriors guide lists each item.

County permits, community review, and an absent owner

Martis Camp homes carry Truckee addresses but sit in unincorporated Placer County, outside the Tahoe Regional Planning Agency's basin boundary, so building permits go through Placer County. Private communities like this commonly have architectural review, and we confirm that process before ordering material. Many homes are used seasonally, so we document hidden damage with photos, agree decisions in advance, and keep the house weather-tight each day. Sequencing matters as well: tear-off, weather barrier, and new cladding are staged elevation by elevation so no wall is left open when a mountain storm arrives early.

Why this matters in Martis Camp

  • Specified for Martis Valley / Sierra Alpine conditions
  • James Hardie as the recommended system
  • Correctly detailed weather-resistive barrier and flashing
  • Installed by a crew with 20 years combined experience

Recommended systems for Martis Camp

  • James Hardie
  • fiber cement

Fire-Resistant Siding for Martis Camp homes

The full fire-resistant siding approach — materials, weather-resistive detailing, and the manufacturer standards we install to — is covered on the main service page, then specified for Martis Camp's conditions on this one.

Full Fire-Resistant Siding details →

Our Martis Camp process

  1. Step 1

    Consultation

    We listen to your goals and assess your home on site — exposure, substrate, and architecture.

  2. Step 2

    Design & Proposal

    A clear written proposal with the right system specified for your climate and a transparent scope.

  3. Step 3

    Expert Installation

    Trained crews install to manufacturer best practices with careful weather-management detailing.

  4. Step 4

    Walkthrough & Support

    A final walkthrough, full cleanup, and a clear written record of the scope completed — work we stand behind.

FAQ

Fire-Resistant Siding in Martis Camp — FAQ

Not necessarily. Spot checks show most of Martis Camp as Very High, but at least one point checked fell outside the mapped zones. Check your parcel on the OSFM Fire Hazard Severity Zone viewer.

The Truckee Fire Protection District. It publishes defensible-space zones of 0–5 feet, 5–30 feet, and 30 to at least 100 feet around a home.

Non-combustible cladding and trim, no combustible mulch or stored materials against the foundation, and details that keep needles from collecting where siding meets grade or decks.

No one can promise that. Hardening removes the failure modes you control — combustible cladding, open vents, exposed eaves, debris-trapping decks — and improves the odds, but outcomes also depend on fire behavior, weather, and terrain.

No. Despite the Truckee mailing address, Martis Camp is in unincorporated Placer County, so county building permits apply, plus any community architectural review.

Free Estimate

Fire-Resistant Siding in Martis Camp — Free Estimate

Serving Martis Camp and the surrounding Placer County. No pressure, no obligation.

Free, No-Obligation Estimates 20 Yrs Combined Experience Fire-Resistant Systems
(530) 772-5057Free Estimate